Printed Yagi Antenna - RF Cafe Forums

RF Cafe Forums closed its virtual doors in late 2012 mainly due to other social media platforms dominating public commenting venues. RF Cafe Forums began sometime around August of 2003 and was quite well-attended for many years. By 2012, Facebook and Twitter were overwhelmingly dominating online personal interaction, and RF Cafe Forums activity dropped off precipitously. Regardless, there are still lots of great posts in the archive that ware worth looking at. Below are the old forum threads, including responses to the original posts. Here is the full original RF Cafe Forums on Archive.org

-- Amateur Radio

-- Anecdotes, Gripes, & Humor

-- Antennas

-- CAE, CAD, & Software

-- Circuits & Components

-- Employment & Interviews

-- Miscellany

-- Swap Shop

-- Systems

-- Test & Measurement

-- Webmaster

sag
 Post subject: Printed Yagi Antenna
Posted: Sat Feb 04, 2006 10:34 am 
Hay all,

I want to design a printed Yagi-Uda antenna, does anyone know how to do it? do I print at both sides of the material, where do I connect the parazitic elements etc.

Freq is not important as long as you give you answers in wave-lenght terms.

10x

Posted  11/12/2012