Tech/Engineer Looking for Ops - RF Cafe Forums

RF Cafe Forums closed its virtual doors in late 2012 mainly due to other social media platforms dominating public commenting venues. RF Cafe Forums began sometime around August of 2003 and was quite well-attended for many years. By 2012, Facebook and Twitter were overwhelmingly dominating online personal interaction, and RF Cafe Forums activity dropped off precipitously. Regardless, there are still lots of great posts in the archive that ware worth looking at. Below are the old forum threads, including responses to the original posts. Here is the full original RF Cafe Forums on Archive.org

-- Amateur Radio

-- Anecdotes, Gripes, & Humor

-- Antennas

-- CAE, CAD, & Software

-- Circuits & Components

-- Employment & Interviews

-- Miscellany

-- Swap Shop

-- Systems

-- Test & Measurement

-- Webmaster

TFM Technology

Post subject: Tech/Engineer Looking for Ops Posted: Fri Mar 04, 2005 3:24 pm

I have been I tech for almost 9 years, and I have done the following:

- design VCO's 900MHZ-4.6GHz with minimal support

- extensive PCB design using Protel up to 99SE version

- turnkey manufacturing, prototyping on a contract basis

- calibration

- test fixture design and implementation

- Technical documents such as test procedures and design documentation.

- strong hardware design abilities

- able to learn new things with little or no assistance

- excellent problem solving skill and observation

- research, development , and data collection

This is what I can think of off the top of my head. If you think you can use these skills. Call 954-649-0705. I will perform contractual work from my location. I also can provide offshore sourcing for low cost PCB's as well as low cost proffesional SMT assembly.

Posted  11/12/2012