Small size and ruggedness are two important factors in the selection of bandpass filters for military and OEM applications. Monolithic ceramic block combline bandpass filters not only offer a size advantage in UHF through L-band frequencies; they also have other characteristics that make them extremely attractive when compared to other technologies. The filters are characteristically lower in cost and have relatively good insertion loss due to their high Q material (Q>10,000). This paper describes the design technique used for ceramic bandpass filters. The procedure for designing ceramic bandpass filters is straightforward and relies on standard filter theory. It is only in the construction stage of the | Design Procedure The design procedure for these combline filters is based on papers by Matthaei (1) and Cristal (2) which include descriptions of the physical structures required for their realization. It is necessary to determine the order of a filter based on a given bandwidth, rejection, loss, etc. Using Reference 1, a low pass to bandpass transformation is performed. 
For a Chebyshev response, n is obtained from: 
Since n cannot be a fraction, it will be rounded up to the next highest integer. Once n is calculated, the low pass prototype element values (or g values) are obtained (1). Using the above information, coupling coefficients are given by (1): 
To excite the TEM mode, resonators are located in close proximity to one another. In doing that they become electromagnetically coupled via their associated electric and magnetic fields. While designing such devices, the desired degree of coupling is usually known, and it is required in order to determine the spacing necessary to achieve this coupling. By using coupling coefficients (from equation 4), Reference 2, and transmission line theory, coupling coefficients are adjusted. | 
