•−• ••−• −•−• •− ••−• • RF Cafe in Morse Code: Hear It
Amplitude Modulation
Amplitude modulation uses the instantaneous amplitude of a modulating signal (voice, music, data, etc.) to directly vary the amplitude of a carrier signal. Modulation index, m, is used to describe the ratio of maximum voltage to minimum voltage in the modulated signal. If the modulating signal is equal in magnitude to the carrier, then m = 1 and the modulated signal varies from a scaled maximum of unity down to zero (see figure below). When m = 0, no modulation of the carrier is performed. If m is greater than 1, the carrier is actually cut off for some period of time, and unwanted harmonics are created at the transmitter output.
In the frequency domain, the carrier frequency is flanked on both sides by mirror image copies of the modulating signal.
wM1 = wc ± wm1, wM2 = wc ± wm2
AM General Equation
Let the carrier be xc(t) = Xc·sin (wct), and the modulating signal be xm(t) = Xm·sin (wmt)
Then x(t) = Xc·[1+m·sin (wmt)]·sin (wct)
Modulation Index
m =
Vmax - Vmin Vmax + Vmin
In the following examples, the carrier frequency is nine times the modulation frequency. Red (dashed) lines represent the modulation envelope. Blue (solid) lines represent the modulated carrier.
100% Modulation
Here, the maximum voltage (Vmax) is 2 V and the minimum (Vmin) is 0 V. From the modulation index formula:
m =
2 - 0 2 + 0
= 1.0
50% Modulation
Here, the maximum voltage (Vmax) is 3 V and the minimum (Vmin) is 1 V. From the modulation index formula:
m =
3 - 1 3 + 1
= 0.5
25% Modulation
Here, the maximum voltage (Vmax) is 1.25 V and the minimum (Vmin) is 0.75 V. From the modulation index formula:
m =
1.25 - 0.75 1.25 + 0.75
= 0.25
150% Modulation
Here, the maximum voltage (Vmax) is 2.5 V and the minimum (Vmin) is -0.5 V. From the modulation index formula:
m =
2.5 - (-0.5) 2.5 + (-0.5)
= 1.5
Note: AM waveforms created with MathCAD 4.0 software.
Class
Conduction Angle
Maximum Efficiency
Description
A
360º
25%
Device is biased in to conduct in the linear region all the time.
AB
> 180º, << 360º
---
Two devices connected like a Class B, but biased to conduct somewhere between Class A and Class B.
B
180º
78.5%
Two devices in series with the output taken at the common junction. Both devices biased to conduct in the linear region for opposite half a cycle, i.e., they are never on at the same time.
C
> 0º, < 180º
---
Device is biased to turn on after a certain input threshold voltage is exceeded. Very efficient, but creates distortion.
D
100%
Used to switch completely on or completely off.
E
Used for rectangular input signals.
Note: Numbers shown are NOT total page views; they are unique IP addresses for each 24-hour period (i.e., unique visitors). Typical page view counts are at least twice the reported unique visitor number.
RF Cafe Erie, PA (814) 833-1967
A Disruptive Web Presence™ GPS Coordinates: N 42°04.577', W 080°11.757'
