|
|
|
Dipole simulation with ansoft designer - RF Cafe Forums
|
| nenou_renardo
|
|
Post subject: Dipole simulation with ansoft designer
Posted: Tue Jan 24, 2006 4:03 am
|
|
Joined: Tue Jan 24, 2006
3:48 am
Posts: 1
Location: Toulouse FRANCE
|
|
Hello,
I'm trying to design a dipole antenna
with ansoft designer.
This dipole must be connected
to RFID CHIP.
Lambda/4 Lambda/4
=======[]=======
RFID
CHIP
I've separated the dipole into
two rectangle of lambda/4 (0.1mm separate them)
and i've selected the edges and add a port but the
software say "edges do not define a valid port".
In the help, i've found that:"The edges must
be co-linear"
How can i simulate it???
Thanks You for your future Help
|
|
Posted 11/12/2012
|
|
|
|
|
