chip antenna question - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

keitaro310

Post subject: chip antenna question

Posted: Tue Oct 04, 2005 5:08 am

Lieutenant

Joined: Tue Oct 04, 2005 5:04 am
Posts: 1

I am currently designing a zigbee sensor module for my graduate project. I am planning to design without a RF SPDT switch due to cost limitations. That is, one antenna for Tx and one antenna for Rx. Since chip antennas are dependent on the layout of the board, are there any disadvantages in designing two chip antennas in one board.
Hope someone can help me out.

Posted 11/12/2012

RF Cafe began life in 1996 as "RF Tools" in an AOL screen name web space totaling 2 MB. Its primary purpose was to provide me with ready access to commonly needed formulas and reference material while performing my work as an RF system and circuit design engineer. The World Wide Web (Internet) was largely an unknown entity at the time and bandwidth was a scarce commodity. Dial-up modems blazed along at 14.4 kbps while tying up your telephone line, and a lady's voice announced "You've Got Mail" when a new message arrived...

All trademarks, copyrights, patents, and other rights of ownership to images and text used on the RF Cafe website are hereby acknowledged.

My Hobby Website: AirplanesAndRockets.com

My Daughter's Website: EquineKingdom

Innovative Power Products (IPP) CoolChips - RF Cafe

Windfreak Technologies Frequency Synthesizers - RF Cafe

RF Electronic Stencils Symbols Visio Shapes Office