Search RFC: |                                     
Please support my efforts by ADVERTISING!
About | Sitemap | Homepage Archive
Serving a Pleasant Blend of Yesterday, Today, and Tomorrow™
Vintage Magazines
Electronics World
Popular Electronics
Radio & TV News
QST | Pop Science
Popular Mechanics
Radio-Craft
Radio-Electronics
Short Wave Craft
Electronics | OFA
Saturday Eve Post
Please Support My Advertisers!
RF Cafe Sponsors
Aegis Power | Centric RF | RFCT
Alliance Test | Empower RF
Isotec | Reactel | SF Circuits

Formulas & Data

Electronics | RF
Mathematics
Mechanics | Physics


Calvin & Phineas

kmblatt83@aol.com

Resources

Articles, Forums, Radar
Magazines, Museum
Radio Service Data
Software, Videos


Artificial Intelligence

Entertainment

Crosswords, Humor Cogitations, Podcast
Quotes, Quizzes

Parts & Services

1000s of Listings

        Software:

Please Donate
RF Cascade Workbook | RF Symbols for Office
RF Symbols for Visio | RF Stencils for Visio
Espresso Engineering Workbook
Crane Aerospace & Electronics (RF & Microwave) - RF Cafe

discrete PA - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews
-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Tom
Post subject: discrete PA
Unread postPosted: Thu Mar 24, 2005 4:33 pm

Hi, I need to design a discrete PA circuit. Band: PCS1900(1850 to 1910MHz), power 5W, Vcc=6V. GSM input signal

Can any of you suggest a transistor supplier that supplies transistors which can handle these requirement?

Regards,
Tom


Top


Joe
Post subject: power amp
Unread postPosted: Fri Mar 25, 2005 11:57 am

Try Eudyna

http://www.us.eudyna.com/products/MW.htm

or APT

http://www.advancedpower.com/Products/R ... fault.aspx

These two should cover most applications. You may need to use a higher power device at lower voltage to meet your requirements.


Top


Guest
Post subject:
Unread postPosted: Fri Mar 25, 2005 12:57 pm

Joe,
Thanks for the information, and I will look into them.

Regards,
Tom




Posted  11/12/2012
Crane Aerospace & Electronics (RF & Microwave) - RF Cafe