Search RFC: |                                     
Please support my efforts by ADVERTISING!
About | Sitemap | Homepage Archive
Serving a Pleasant Blend of Yesterday, Today, and Tomorrow™
Vintage Magazines
Electronics World
Popular Electronics
Radio & TV News
QST | Pop Science
Popular Mechanics
Radio-Craft
Radio-Electronics
Short Wave Craft
Electronics | OFA
Saturday Eve Post
Please Support My Advertisers!
RF Cafe Sponsors
Aegis Power | Centric RF | RFCT
Alliance Test | Empower RF
Isotec | Reactel | SF Circuits

Formulas & Data

Electronics | RF
Mathematics
Mechanics | Physics


Calvin & Phineas

kmblatt83@aol.com

Resources

Articles, Forums, Radar
Magazines, Museum
Radio Service Data
Software, Videos


Artificial Intelligence

Entertainment

Crosswords, Humor Cogitations, Podcast
Quotes, Quizzes

Parts & Services

1000s of Listings

        Software:

Please Donate
RF Cascade Workbook | RF Symbols for Office
RF Symbols for Visio | RF Stencils for Visio
Espresso Engineering Workbook
LadyBug LB5954L Power Sensor with LAN Option - RF Cafe

spice simulation - expert advice needed - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews
-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

balajisu
Post subject: spice simulation - expert advice needed Posted: Thu Aug 24, 2006 6:03 pm

Captain


Joined: Wed Jul 06, 2005 5:54 pm
Posts: 24
Location: Germantown,MD
Simulating a Voltage Regulator spice model - Performing Transient analysis with Voltage regulator loaded with current source set with 20KHx pulse input. Voltage regulator is a fixed 5V regulator.
When I measure the regulator output after the simulation it seems to be stable.

When i load the regulator with a LPF and then run a similar simulation I see the regulator output to be ringing?

can anyone throw some light on whats happening in this situation?

Any help in this regard would be much appreciated




Posted  11/12/2012
LadyBug LB5954L Power Sensor with LAN Option - RF Cafe