Search RFC: |                                     
Please support my efforts by advertising!
About | Sitemap | Homepage Archive
Serving a Pleasant Blend of Yesterday, Today, and Tomorrow™
Vintage Magazines
Electronics World
Popular Electronics
Radio & TV News
QST | Pop Science
Popular Mechanics
Radio-Craft
Radio-Electronics
Short Wave Craft
Electronics | OFA
Saturday Eve Post
Please Support My Advertisers!

Aegis Power | Centric RF | RFCT
Alliance Test | Empower RF
Isotec | Reactel | SF Circuits

Formulas & Data

Electronics | RF
Mathematics
Mechanics | Physics


Calvin & Phineas

Resources

Articles, Forums, Radar
Magazines, Museum
Radio Service Data
Software, Videos


Artificial Intelligence

Entertainment

Crosswords, Humor Cogitations, Podcast
Quotes, Quizzes

Parts & Services

1000s of Listings

        Software: RF Cascade Workbook | RF Symbols for Office
RF Symbols for Visio | RF Stencils for Visio
Espresso Engineering WorkbookCafe Press
Noisecom

Zenith 6-Tube All-Wave Superhet. Chassis No. 5634
November 1936 Radio-Craft

November 1936 Radio-Craft

November 1936 Radio Craft Cover - RF Cafe[Table of Contents]

Wax nostalgic about and learn from the history of early electronics. See articles from Radio-Craft, published 1929 - 1953. All copyrights are hereby acknowledged.

Zenith Chassis No. 5634 (RadioMuseum.org) - RF CafeI have been scanning and posting Radio Service Data Sheets like this one featuring the Zenith 6-Tube All-Wave Superheterodyne Chassis No. 5634 radio receiver for many years now. There are still many people who restore and service these vintage radios, and often it can be difficult or impossible to find schematics and/or tuning information. The thumbnail image of the Zenith Chassis No. 5634 came from the RadioMuseum.org website.

Zenith 6-Tube All-Wave Superheterodyne Chassis No. 5634

Zenith 6-Tube All-Wave Superhet. Chassis No. 5634, November 1936 Radio-Craft - RF CafeThe anode grid of V1 is 175 V. All measurements are made with a 1,000 ohms-per-volt meter, from socket to ground. and with the antenna and ground disconnected. The line voltage for above readings is 112 V. Power consumption of the receiver is 75W.; the power output is 4 W. The LF. stage is aligned by connecting the leads from the signal generator to ground and the control grid cap of V1. Set test oscillator at 456 kc. and adjust all 4 trimmers for highest output. Then change leads to antenna and ground of receiver and adjust the wave trap for minimum output reading. Set generator at 6 mc. and adjust oscillator trimmer on gang condenser for correct dial reading on band B. Set generator to 1,400 kc. and adjust oscillator trimmer of band A for dial setting, also adjusting antenna trimmer for best output. Set generator to 18 mc. and align receiver dial at this position for highest output. Set generator to 600 kc. and rock receiver dial on band A to best output. Readjust trimmers at 1.400 kc.

 

 

Posted January 20, 2017


Radio Service Data Sheets

These schematics, tuning instructions, and other data are reproduced from my collection of vintage radio and electronics magazines. As back in the era, similar schematic and service info was available for purchase from sources such as SAMS Photofacts, but these printings were a no-cost bonus for readers. There are 255 Radio Service Data Sheets as of April 30, 2025.

Noisecom